Rotrics Manual
CtrlK
ROTRICS.COMDownload CenterGet Help in ForumSubmit a Ticket
  • Rotrics DexArm User Manual V1.2
  • ✨Getting Started
    • 🎮Hands-on Guide
    • 🎨Writing/Drawing
    • 🎇Laser Engraving
    • 🛸3D Printing
    • 🦾Teach & Pneumatic
    • 📷Computer Vision
    • 🔄Rotary Module
    • Sliding Rail Kit
    • Conveyor Belt Kit
  • 💻Product Overview
    • 🗺️Product Overview
    • 💾Software - Rotrics Studio
    • 🍴Accessories
  • 🔧FAQ & Troubleshooting
    • ❓FAQs
      • Received an Error message in Rotrics Studio?
      • How to toggle developer tools on Rotrics Studio
      • How to re-calibrated DexArm or reset encoder values?
      • How to upgrade DexArm's firmware?
      • How to upgrade the touchscreen firmware?
      • How to send third-party G-code files with Rotrics Studio?
      • How to replace filament?
      • How to change touchscreen language?
      • How to execute SD card files?
      • Why can't I copy G-code files to the Touchscreen directly?
      • How to write/draw with different colors?
      • Why it misses part of the image when drawing?
      • How to level DexArm manually?
      • Why my 3D printing module is clogged?
    • 🔑Troubleshooting
  • ⌨API(G-code)
    • Introduction
    • Marlin Original Commands
Powered by GitBook
On this page
  • Most Common FAQs
  • General
  • Writing&Drawing
  • Laser Engraving
  • 3D Printing
  • Teach&Pneumatic

Was this helpful?

  1. 🔧FAQ & Troubleshooting

❓FAQs

📅Update: 2020/08/17

Read the corresponding answer for the frequently asked questions by clicking the page link to the particular topic below or jump to the corresponding page in the LEFT/TOP LEFT navigation list.

Most Common FAQs

How to toggle developer tools on Rotrics StudioHow to re-calibrated DexArm or reset encoder values?How to upgrade DexArm's firmware?How to upgrade the touchscreen firmware?How to send third-party G-code files with Rotrics Studio?How to replace filament?

General

How to upgrade DexArm's firmware?How to upgrade the touchscreen firmware?How to re-calibrated DexArm or reset encoder values?How to send third-party G-code files with Rotrics Studio?How to change touchscreen language?How to execute SD card files?Why can't I copy G-code files to the Touchscreen directly?

Writing&Drawing

How to write/draw with different colors?

Laser Engraving

Why it misses part of the image when drawing?

3D Printing

How to replace filament?How to level DexArm manually?Why my 3D printing module is clogged?

Teach&Pneumatic

PreviousTouchscreenNextReceived an Error message in Rotrics Studio?

Last updated 1 month ago

Was this helpful?