Rotrics Manual
ROTRICS.COM
Download Center
Get Help in Forum
Submit a Ticket
Search…
English
Rotrics DexArm User Manual V1.2
✨Getting Started
🎮Hands-on Guide
🎨Writing/Drawing
🎇Laser Engraving
🛸3D Printing
🦾Teach & Pneumatic
📷Computer Vision
🔄Rotary Module
Sliding Rail Kit
Conveyor Belt Kit
Tips & Tricks
💻Product Overview
🗺️Product Overview
💾Software - Rotrics Studio
🍴Accessories
🔧FAQ & Troubleshooting
❓FAQs
🔑Troubleshooting
“G-code sending task started...” Error
Laser module won't light
Rotrics Studio "Internal error occurred"
Failed to upgrade Rotrics DexArm's Firmware
Fix the clogged 3D printing nozzle
Replace the cracked case
How to Fix a Black Screen after upgrading the firmware?
DexArm couldn't connect to my computer
DexArm beyond limits/stuck problem
DexArm movement accuracy problem
The pen doesn't write with ink
3D printing module won't heat up
The Arm doesn't move, only filament comes out
Software connect problem after safety enclosure installed
Safety enclosure wiring changes
⌨API(G-code)
Introduction
Marlin Original Commands
Powered By
GitBook
Fix the clogged 3D printing nozzle
❗️
Warning:
Make sure the 3D printing module is un-heated before replacing it.
1. Unscrew the two hex screws with an Allen wrench.
2. Unscrew the heater and the temperature sensor
Be careful, don’t break the temperature sensor‘s glass cover.
3. Spinout the hot end and the nozzle at the counter-clockwise direction.
4. Spin on the spare hot end and nozzle.
5. Screw on the heater and the temperature.
6. Screw on the two hex screws.
Previous
Failed to upgrade Rotrics DexArm's Firmware
Next
Replace the cracked case
Last modified
1yr ago
Copy link